Information

Manufacturers

Specials

List of products by manufacturer BSI Glues & Adhesives

Showing 1 - 8 of 8 items
  • $2.99

    1/2 oz (14.7ml) size. INSTA-CURE™ has a water-thin viscosity that wicks deep into joints by capillary action and cures in a matter of a few seconds. Surfaces to be bonded must be tight fitting and should be held together while you apply the CA around the edges of the seam. At the moment CAs cure,

    $2.99
  • $4.99

    1 oz. (29.5 ml) size. INSTA-CURE™ has a water-thin viscosity that wicks deep into joints by capillary action and cures in a matter of a few seconds. Surfaces to be bonded must be tight fitting and should be held together while you apply the CA around the edges of the seam. At the moment CAs cure,

    $4.99
  • $2.99

    1/2 oz (14.7ml) size. INSTA-CURE+™ is a higher viscosity CA for loose fitting joints in which the adhesive must bridge gaps. Normally, the thicker CA is applied to one surface and then the parts are held tightly together for about 5 to 15 seconds. For large surface areas, including those with

    $2.99
  • $4.99

    1 oz. (29.5ml) of INSTA-CURE+™ is a higher viscosity CA for loose fitting joints in which the adhesive must bridge gaps. Normally, the thicker CA is applied to one surface and then the parts are held tightly together for about 5 to 15 seconds. For large surface areas, including those with close

    $4.99
  • $3.29

    1/2 oz. (14.7ml). MAXI-CURE™ extra thick CA is the best CA for most plastics, including GE’s Lexan MAXI-CURE™ is the best choice for plastic model assembly. When used with INSTA-SET™, it works better than any putty for modifying or filling voids. It can be carved with a knife or razor blade

    $3.29
  • $5.29

    1 oz. (29.5ml)plastic bottle. MAXI-CURE™ extra thick CA is the best CA for most plastics, including GE’s Lexan. MAXI-CURE™ is the best choice for plastic model assembly. When used with INSTA-SET™, it works better than any putty for modifying or filling voids. It can be carved with a knife

    $5.29
  • $4.99

    2 oz. (59ml) bottle INSTA-SET™ is a catalyst which acts as an accelerator that allows CAs to quickly cure in thick layers by enhancing the alkaline conditions during polymerization. INSTA-SET™ in a spray bottle is normally used to cure the CA that flows from joints when parts are pressed

    $4.99
  • $2.99

    1 oz. (29.5ml) bottle. UN-CURE™ debonder will soften cured CA. If parts are bonded incorrectly or your fingers are stuck together, a few drops of UN-CURE™ will dissolve the CA in about a minute. Apply on bonded skin and roll apart fingers. Once stuck, use acetone to clean off softened CA, then

    $2.99
Showing 1 - 8 of 8 items